Talk to a Silverado 1500 Sales Tech
1-888-706-1096
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install Husky Removable Pivoting Mud Flaps on your Silverado

Tools Required
  • Power Drill with 1/8” drill bit
  • Hex Head Drill Attachment

PACKAGE CONTENTS:

2 - Pivoting Mud Flap & Flange
2 - Mounting Bracket & Tube
8 - SS Self Drilling Screws
20 - Washers
6 - SS Button Head Cap Screws
6 - Nyloc Hex Nuts

Pivoting Mud Flap  Driver’s Side (1) 

Pivoting Mud Flap  Passenger’s Side (1) 

VEHICLE PREPARATION:

Your vehicle’s mounting area should be cleaned prior to the installation of your new Husky Long John Flares. 

Installation


Read all directions thoroughly prior to the installation of your Mud Flaps. 

1. Clean the mounting location on your
vehicles fender.


2. Assemble the upper flange bracket with the SS button head cap screws through the flange, mudflap, washer and into the nyloc hex nut. 

Note: The 1” soild strip installs on the outside of the flange 


3. Find the proper mounting location for the mounting bar by holding the bar and mud flap in the wheel well opening. 

Note: These are general mounting guidelines and the mudflap can be mounted in many different ways to provide whatever cover-age you deem necessary. 


4. Use supplied self drilling screws and washers to fasten the mounting bar to the frame. 


5. Slide the mud flap and flange over the mount­ing bar and tighten the bolt to hold the mud­guard at your desired angle 


6. Repeat steps 1-5 on the opposite side

Best Sellers