Talk to a Silverado 1500 Sales Tech
1-888-706-1096
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install Addictive Desert Designs ADD Lite Side Steps (07-13 Silverado 1500 Crew Cab) on your Chevy Silverado

Installation Time

1 hours

Tools Required
  • 3/4” Socket
  • Ratchet
American Muscle
Shop Parts in this Guide

PREPARATION

1. Disconnect the negative terminal on the battery. Park the vehicle on level ground and set the emergency brake.

2. We recommend reading through the installation instructions in whole before performing the work.

3. Estimated Installation Time: 1 Hour

4. You will need the following tools:
a. 3/4” Socket
b. Ratchet
Note: this installation requires 2 people for best results

5. Included in Kit:
Reuse Stock Hardware

INSTALLATION

1. Lay your Side Steps out and put them on the correct side of the vehicle. The raised mount goes towards the rear of the truck. (Fig A)  


2. On one side of your vehicle, find the cab mount bolts. There are three 3/4” Bolts that can be seen from underneath the vehicle. Refer to Fig B. Remove these three bolts.  


3. Hold your step in place, then secure it to the frame using the bolts you removed in Step 2. (Fig C) If the rubber pucks dropped off the mounts when you removed the bolts, please arrange them as shown in Fig D  


4. Align the Side Step so that it is centered left to right and sits straight in relation to the bottom of the doors. Then, tighten the mounting bolts to the manufacturer’s specification.

5. Repeat Steps 2-4 on the other side of the vehicle.

6. Stand back and enjoy your new ADD Lite Side Steps.

7. Check and re-tighten if needed, all mounting bolts after 100 miles and periodically thereafter.


Best Sellers