Talk to a F-150 Sales Tech
1-888-706-1096
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

How to Install Raxiom 50 in. Curved LED Light Bar Windshield Mounting Brackets on your F-150

1. Using templates and lay in
rain gutter, Line up with the
corner of the windshield.


2, Drill marked holes with a pilot drill bit and then work up to 8 318" drill bit to finish

**NOTE** Start using a 5/64t"
drill bit and SLOWLY step up
in small increments to 3/8" !!


3. Insert supplied Grip-Bert into holes. Use tool to fasten Grip-Bert by tightening down the boltwhile placing a wench On the center nut. Do not let Grip-Bert turn while tightening (Small amount of silicone applied to splined area recommended )


4,Tighten all Grip-Serts flush to the body.


5, Repeat steps 1-4 on the Driver side.


6. Place rubber gasket between
the cab & the bottom of the
bracket. Install the /4-20 x 3/4"
Stainless Steel safety torx bolts
& rubber coated washer with
supplied driver bit tool. Snug
bolts, but do not fully tighten,


7. Bracket should look like this.


8. lnstall driver side bracket onto LED Eight bar using light bar hardware.


9. Slide opposite side of light bar into passenger side bracket.


10.Fasten light to passenger side LRM bracket. Drop driver side down and align with holes.


11.Install bolts into bracket and adjust light bar to be level. Torque down all hardware.


12. Route power wire down wind-shield and wire light bar as noted in light bar instructions. We recommend using some black silicone on the bottom of the wire holding it down in place.