Grants 20 Horsepower and Other Performance.
Practically rolling out the red carpet to invite huge amounts of cold, high-oxygen air into your 2010-2011 Raptor’s engine, the Injen Power-Flow Polished Cold Air Intake features large diameter mandrel bent tubing and an oversized filter to ensure maximum aspiration. Built from aluminum and other tough, permanent materials, the Power-Flow is a great example of cutting edge USA engineering. You can expect your Raptor’s 6.2L engine to crank out up to +21 horsepower and +19 ft-lbs of torque. What’s more, it makes the throttle more responsive, giving you more control over that new power.
Works Fully with Factory Tune.
The Injen Power-Flow Polished Cold Air Intake can be installed and used to full effect with the factory tune still in place. If you flash your truck’s ECU with an aftermarket tune to support other parts, this CAI continues to function as normal, too. The MAF sensor does not require recalibration thanks to Injen’s MR tech.
Extremely Effective Oil-Free Filter.
The blue filter found in the Injen Power-Flow Polished Cold Air Intake is manufactured from high-flow nanofiber. This material filters out 100% of 3-micron particulates, and over 80% of particles as small as 1 micron. The filter material is oil-free, meaning that when you wash and reuse it (the element can be used repeatedly), you don’t need to worry about under- or over-oiling.
Resilient Build, Stylish Finish.
USA-made to ensure topnotch craftsmanship and quality control, the Injen Power-Flow Polished Cold Air Intake mounts a blue nanofiber air filter (which also includes 4 layers of surgical cotton) to a mandrel-bent high flow intake tube. The tube is manufactured from aerospace grade 6061 aluminum, rust-proof and taking a pleasing high polish. The heat shield is black powder-coated with a textured finish to match other common trim pieces.
Mega Ram Tech MAF Housing.
The intake tube of the Injen Power-Flow Polished Cold Air Intake steps down in diameter at the point where the built-in MAF housing is located. This “Mega Ram” tech allows the MAF to function as normal without recalibration despite the bigger diameter and massively increased indraft of the intake tube.
Bolts On without Modifications.
Attaching to your vehicle with included precision cut CNC-machined brackets, the Injen Power-Flow Cold Air Intake is a direct bolt-on replacement for the stock intake. All the hardware you need is packaged along with this part. Only hand tools are required for installation.
Lifetime Warranty with Activation Needed.
The Injen Power-Flow Polished Cold Air Intake is supplied with a limited lifetime manufacturer's warranty from Injen. You must return the warranty card within 30 days of purchase to benefit from this warranty, however.
49-State On-Road Legal.
Injen designs the Power-Flow Polished Cold Air Intake to be 49-state legal. This induction component does not meet the standards established by the state of California for CARB compliance and therefore cannot be legally purchased or installed in that state. The CAI is also not street-legal in other jurisdictions where CARB regulations are in use (though it may be legal for off-roading and/or the track).
This Injen PF Series Polished Air Intake System is designed to fit the 2010-2011 SVT Raptors powered by the 6.2L engine.