How to Install Husky X-Act Contour Front Floor Liners - Cocoa (15-18 SuperCab, SuperCrew) on your Ford F-150

Thank you for selecting X-act Contour™ Front Floor Liners from Husky Liners Inc. Your new front floor liners are custom molded to fit your specific vehicle’s floor board. The liners are made to take the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new floor liners. However, do not remove the factory-installed carpeting. 

Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest way to clean your liners is with a damp cloth or sponge and soap and water. Windex®, 409® and ArmorAll® type cleaners work as well. 

TO INSTALL DRIVER’S SIDE LINER SIMPLY POSITION LINER OVER EXISTING RETAINER AND PRESS DOWN TO SEAT LINER OVER THE RETAINER. INCLUDED IN YOUR PACKAGING IS AN ADDITIONAL RETAINING POST FOR THE PASSENGER SIDE. SEE INSTALLATION DETAILS ON THE BACK OF THIS PAGE. 

YOUR NEW LINER SET INCLUDES OUR NEW FLOOR LINER RETAINING CLIP SYSTEM. THIS RETAINING CLIP GIVES MOVEMENT RESTRAINT WHILE KEEPING SPILLS AND DEBRIS TRAPPED INSIDE THE LINERS. TO INSTALL THE HUSKY® LINER RETAINING CLIP ON THE PASSENGER SIDE LINER, SIMPLY FOLLOW THE INSTRUCTIONS BELOW: 

1) Pre fit your new X-act Contour floor liner in your vehicle (Image 1).
2) Insert the screw-in carpet retention screw into the bottom of the X-act Contour liner (Image 2).
3) Press down on the liner to pre-mark the carpet screw into the carpet (Image 3).
4) Screw the carpet screw into the carpet with a flat blade screwdriver (Image 4).
5) Press the X-act Contour liner over the top of the carpet screw post (Image 3).​