FREE 1 to 3-Day Delivery on Orders $119+ Details
Parts list:
1 Air filter ( P/N 24-90039 or Pro Dry S ™ 21-90039 )
1 Housing, wrinkle black
1 Tube
1 Adapter, MAF
1 Gasket, MAF adapter
1 Coupler, straight 3-1/4” x 2”L
1 Coupler, hump 3-1/2” x 3”L
1 3/4” trim seal @ 18.5”L
1 5/8” hose @ 21”L
2 Clamp, #060
2 Clamp, #052
2 Clamp, mini #008
1 Gasket, MAF sensor
2 Spacer, nylon 1/2” x 1/4” x 1/8”
2 Screws, hex M4 x .7 x16
4 Screws, hex M6 x 1 x 20
4 Washers, wavy M6
1 Washer, flat
1 Screw, hex M6 x 1 x 12
2 Spacer, plastic black
2 Screw, hex 1/4”-20 x 1.25
2 Locknut, hex 1/4”-20
2 Washer, fender 1/4” x 7/8”OD
1 Torx bit, T-20
1 Adapter, injection molded 6”
STEP 1: Complete Stock Intake.
STEP 2: With 5/16” nut driver loosen clamp at throttle body. Disconnect and remove OE crank case line.
STEP 3: Loosen the clamp at air box side and remove OE intake tube.
STEP 4: Disconnect bottom MAF sensor harness under air box bracket.
STEP 5: Lift up and remove OE air box out of vehicle.
STEP 6: Disconnect band clamp and with flat head screwdriver, disconnect other end of MAF harness. Carefully pull out OE MAF sensor tube.
STEP 7: With T-20 torx bit remove MAF sensor and ( with gasket, nylon spacers and screws provided ) install into new tube. Make sure gasket and nylon spacers are between sensor and tube.
STEP 8: Install 6” adapter inside of housing. With gasket provided between outside of housing and MAF tube adapter install hex screws w/ wavy washers provided. Tighten using 10mm socket or wrench.
STEP 9: With black plastic spacer, place inside of OE air box grommets. Install housing with 1/4”-20 screw, nut and washers provided.
STEP 10: Place 5/8” hose to new tube with mini clamp provided and tighten using 1/4” nut driver. Install couplers with clamps provided to new tube.
STEP 11: Install new tube to throttle body and intake housing. Tighten clamps with 5/16” nut driver. Finish install on crank case line with mini clamp and tighten.
STEP 12: Tighten housing using 11mm socket or wrench. Install 3/4” trim seal to housing.
STEP 13: Reconnect both ends of MAF sensor harness.
STEP 14: Install air filter and tighten using 5/16” nut driver.
STEP 15: Your installation is now complete. Please check all bolts and clamps perodically. Re-tighten if necessary. Thank you for choosing aFe!