FREE 1 to 3-Day Delivery on Orders $119+ Details
Carefully read entire instructions thoroughly before using this product.
NOTE:
• Remove deflators after deflation.
• DO NOT leave attached to valve stem.
• Keep deflators clean and dry.
• Do not interchange components.
STEP 1: Deflate a spare/extra tire to your preferred deflation pressure.
STEP 2: With the lock ring and adjusting cap wound down, screw your deflator on the valve stem. (Be sure to make sure the threads are clean and in good condition)
STEP 3: Loosen cap (counter-clockwise) until deflator pops open, then immediately Tighten cap to the position where the air stops exhausting.
STEP 4: Turn lock ring up to adjust cap and tighten.
STEP 5: Installation is now complete and set to your preferred deflation pressure. -
NOTE: Adjustments to your deflators can be made at the rate of 3psi per half turn of the adjusting cap. When the tire pressure and the deflator setting within 8psi, a manual start may be required by fitting the deflator then lifting the center pin to start operation.