How to Install Putco Luminix High Power LED Fog Lights - Pair (14-15 Sierra 1500) on your GMC Sierra

1. Remove a minimum of 5 lower T15 torx headed screws that hold the inner fender well to the vehicle. Carefully pull fender well away from fender to gain access to Fog Lamp cavity. Refer to Figure 1

2. Disconnect factory wiring harness from the back of the fog lamp . Refer to Figure 2

3. Use a Phillips Screwdriver to apply enough pressure to pop out the three mounting pins that secure the fog lamp to the plastic housing. Refer to figure 3

4. Remove fog lamp assembly and set aside for next step as some parts are reused.

1. Remove Putco fog lamps from packaging. Check to see if all parts from Table 1.0 are included

2. Install stainless steel brackets on both fog lamps using 4 - 10-32 X 3/8" screws and locks provided (2 per lamp).

3. Remove adjusting hardware from the original Fog Lamps and reassembly onto new Putco fog lamps. Refer to Figure 4

1. Connect Factory wiring harness to Putco Fog lamp. Ensure connectors are fully seated and can not be pulled back off. Turn on fog lamps to verify everything is working properly

2. Verify that the three black retainers are still installed in the factory mounting bracket of the vehicle.

3. Align the fog lamp so that the adjuster bracket is down and the three mounting posts align with the vehicle's mounting bracket.

4. Using firm pressure press the fog lamp into the three retainers. Ensure all three mounting posts are fully seated and can not be pulled back out easily.

5. Turn on fog lamps to verify everything is working properly

6. Adjust the angle of the fog lamps by turning the adjusting screw from the backside of the fog lamp in the inner fender well.

7. Reinstall the inner fender well screws