How to Install Leitner Designs Bed Rack Load Bar Kit on your Sierra

READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.

1) INSTALL FOUR T-BOLTS INTO THE INNER TOP RAIL OF THE ACS SYSTEM . TWO ON PASSANGER SIDE AND TWO ON DRIVERS SIDE. USING 8MM LOCK NUTS SECURE BRACKETS IN PLACE. BRACKET SHOULD BE CENTERD BETWEEN FRONT AND REAR CROSS BEAMS.TORQUE TO 16 LB-FT (FIG 1)

2) INSTALL 2 T-BOLTS FROM THE TOP DOWN INTO EACH CROSS BAR BRACKET. INSTALL 8MM LOCKNUT TO KEEP T-BOLTS IN PLACE. (FIG 2)

3) SLIDE LOAD BAR ONTO T-NUTS FROM ONE SIDE TO THE OTHER. MAKE SURE LOAD BAR IS CENTERD ON VEHICLE. TIGHTEN M8 NUTS TO 16 LB-FT. INSTALL ENDCAPS