How to Install Airaid PowerAid Throttle Body Spacer on your Ram

Included with your Poweraid Spacer is a sticker with a California Air Resources Board (C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of the engine compartment. Failure to do so may prevent you from passing a smog inspection.

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.

2. Remove air intake hose assembly.

3. Remove throttle body air intake box and save bolts.

4. Remove (3) bolts from the throttle body.

5. Unclip throttle & cruise cables and remove from manifold and throttle lever.

6. Install power plate using (3) 6mm x 50mm bolts and 6mm flat washers. (Ref. “A”)

7. Install throttle & cruise cable bracket and tighten bolts. (Ref. “B”)

8. Install both throttle & cruise cables thru reinforcement ring of throttle cable bracket.

A. Reattach cables to throttle body lever . *First cruise cable then throttle cable

B. Slide and lock both plastic cable retainer s into slot separately.

9. Locate (1) long extension plate using (1) flat head screw to reposition throttle body intake box using saved bolts (Ref. “D” and Step 3)

10. Locate (1) short extension plate with 5/8” thick spacer using (1) flat head screw to reposition throttle body intake box using saved bolts. (Ref. “C” and Step 3)

11. Install air box support bracket using (1) flat head screw & (1) flange nut. (Ref. “E”)

12. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise and kick down cables may require adjustment. Please refer to your vehicles service manual for proper adjustment.

13. Reinstall throttle body air intake assembly using (Step 2) as an example.

14. Reconnect battery cable. Enjoy!

The sound of power...The “whistle” means its working!