Talk to a Sierra 1500 Sales Tech
1-888-706-1096
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$20K Sweeps! 10 Chances to Win! Enter Daily >

Best Sellers

How to Install E & G E-Power Heavy Mesh Upper Overlay Grille - Black (07-13 Sierra 1500) on your GMC Sierra

1. Open the hood and use a flat blade screwdriver to remove the factory push pins securing the top of the factory grille center section to the radiator support panel.


2. Apply masking tape to the painted or chromed opening of the factory grille and around the "GMC" emblem as shown.


3. Align the mesh section onto the back of the E-Power surround. Trim the ends from the supplied # 8 x 1-1/4" black cap plugs and the # 8 x 3/4" black cap plugs and install them over all mounting studs up so that only 3/8" of threads are exposed.


4. Carefullyy align the grille assembly into place and use wide masking tape to hold the grille in place during the hardware installation.


5. Installl the lower u-shaped grille retainers across the bottom of the grille using the supplied #8-32 ESNA half nuts. To install the center bracket, you must break off the small mounting tab (not shown).


6. Installl the upper outer grille retainers using the supplied #8-32 ESNA half nuts (as shown).


7. Use the u-shaped grille retainers on the center upper mounting studs. Due to their location, it will be necessary to use a 9mm wrench to tighten the # 8-32 ESNA half nut. Tighten only until the studs are flush with the back of the ESNA nut.


8 . Align the GMC emblem surround in place and press firmly enough to indent the stud location on the factory grille center bar. Use a 1/4" drill bit to drill through the marks made (not shown).


9. Realign the emblem surround and install the supplied small back plastic washers and the #8-32 ESNA half nuts and tighten to so - cure the emblem surround.


l0. Align the factory radiator support panel back into place and install the plastic push pins and close the hood to finish the installation.




Best Sellers