How to Install AFE Magnum FORCE Stage 1 Pro DRY S Cold Air Intake - Black on your Ram

Complete kit

Complete stock intake.

Loosen hose clamp on the air duct connecting to the airbox. Disconnect the breather hose (if equipped). Move air duct to the side

Loosen the four clips securing the upper portion of the airbox.

Remove upper portion of the airbox. Lift up and remove the factory paper filter.

Insert and tighten your pre-oiled filter into the housing. Do not use any grease or oil.

Insert housing assembly into the lower portion of the factory airbox. Secure housing with the factory airbox clips.

Re-connect air duct to the air filter housing. Tighten the factory hose clamp.

Re-connect your breather hose to the filter nipple. If your vehicle is not equipped with a breather hose, cap off the nipple with with the supplied vacuum cap.

Place enclosed CARB EO sticker on a clean/smooth surface on or near the intake system. EO identification label is required to pass the smog inspection.

Your installation is now complete. Tighten all connections and clamps. Re-check after a few hours.