How to Install Raptor Series 3 in. Round Nerf Side Step Bars - Polished Stainless (02-08 RAM 1500) on your Dodge RAM

Torque Specifications:

For Cab Mount Installations
Cab Mount bolts are torqued to 70 Ft Lbs. All other M8 through M12 sized bolts/nuts are set to 15-20 ft lbs.

Note: When installing the brackets and bars, all hardware must be left loose until all the items are attached.

1. Remove all contents from the package and check stainless steel tubes for any damage. Also, verify that all components and hardware listed above are included before you begin installation. 

2. Read installation manual and installation drawing completely. Understand all brackets and bolts before installation. 

3. Begin installation on the driver's side. Remove the existing body mount bolts from underside of cab on driver side, keep the existing rubber bushing and other components in order.  

Note: Make sure existing washer and rubber bushing is in place. 

4. Install the Rear Bracket using the Rear Cab Mount Bolt as shown in diagram. Place one (1) Rubber Washer between the bracket and the existing rubber bushing. 

5. Place the Plastic Push Nut onto the threaded bolt of the Bolt Plate (5a and 5b). Locate the oblong hole in the side of the body panel near the front and insert one (1) Bolt Plate (5c). 

6. Fasten the Step Bar to the Front and Rear Brackets using one (1) M14 x 60MM Bolt, one (1) M14 Lock Washer and one (1) M14 Flat Washer per bracket. 

7. Fasten the Front and Rear Support Straps to the Step Bar using one (1) Nylon Washer, one (1) M10 Flat Washer, one (1) M10 Lock Washer and one (1) M10 Hex Head Bolt (8a) per strap. 

8. Fasten the Front and Rear Support Straps to the Bolt Plates installed in step 5 using one (1) M10 Hex Head Nut, one (1) M10 Flat Washer and (1) M10 Lock  Washer per strap. 

Repeat these steps for passenger side installation. When all hardware is in place, everything must be tightened. See Page 1 for Torque Specifications.